Announcement
Collapse
No announcement yet.
mal's ozzie S1E2
Collapse
X
-
Comment
-
not to worried about getting it dirty, just hoping i dont roll it into a ball. The balljoints slide into the end of those arms, its the sweep forward and back depending on which side you use them on that iam not sure of. As for the linkage i need the link/arm which comes of the box for what ever model that is below the selector shaft ,if that make sence.
ABY GEAR SHIFT.jpg
everything on the left side of this pic, wont need the other rod will i ??
thanks
mal
Comment
-
time for a update
last time i was trying to get the gearshift to work and after working out i had the wrong one ,and i needed ABY shift rod, still would nt work because the sideways throw was to much for the hole in the tunnel
so
cut and removed more tunnel
which then meant i had to redo the shift tower
made some progress with the gearbox output shafts , covert B4 shaft to suit by removing the circlip and machining down the shank
before
Comment
-
had to drill hole through and machined to take normal bolt not tapered one
then made spacers to suit
rears were more of a challenge ,disregard the plus 45mm i wrote the wrong measurements on the wrong side, this being the short side was plus 5 mm
becasue of the lack of lenght i had to cut and swap the flanges, not ideal but
Comment
Comment