Project - Pete-S2

[piotr]

PM send Alex

[piotr]

Just about to torque up the bottom pulley main bolt and I'm wondering if anyone actually used the sealing compound AMV 188 001 02 ?

[piotr]

And one more thing-call me stupid but why there is a 2 different torque values,with audi spanner or without?what difference does it make what tool I will use?If the bolt should be torqued up to 450Nm it should make no difference what tool I will use to do it up to

[piotr]

image.jpg
I have got this

[piotr]

I was going to fit temporarily my old down pipe and the WG flexy pipe is not lining up at all with DP.the only thing i can think off is that it's because of Wagner EM?
Any idea boys?
IMG_7377.jpg

[SteveH]

I thought the Wagner was a direct replacement?

[SteveH]

And one more thing-call me stupid but why there is a 2 different torque values,with audi spanner or without?what difference does it make what tool I will use?If the bolt should be torqued up to 450Nm it should make no difference what tool I will use to do it up to

The audi tool is an extension for the torque wrench, so I assume the value is lower if you use the tool as it moves the measurement point further from the centre.

[newsh]

I was going to fit temporarily my old down pipe and the WG flexy pipe is not lining up at all with DP.the only thing i can think off is that it's because of Wagner EM?

Any idea boys?

[ATTACH]61960[/ATTACH]

This happened on mine when I swapped to RS2 spec, you can slip a piece of tube down the flexi and bend it a bit to make it work. I think you'll need to take it off and hold it in the vice, bolted to the WG
Make sure flexi is the right way round too, they make a horrible noise if they're backwards.

[newsh]

Or if you drop the DP out the way you might be able to do it in situ ..

[newsh]

Note misalignment

[piotr]

Cheers buddy.I will have to have all exhaust made up from scratch so it's not a problem but I was surprised that I'd don't fit as I tough it's direct replacement

[newsh]

Did you fit an RS2 turbo?

[piotr]

Yes,RS2 Turbo

[newsh]

Yes,RS2 Turbo

Bigger turbo shifts the DP slightly further from the head, WG stays where it is. Flexi is slightly out of line. I guess the RS2 DP is different to compensate for this but I don't know for sure.

[piotr]

Bigger turbo shifts the DP slightly further from the head, WG stays where it is. Flexi is slightly out of line. I guess the RS2 DP is different to compensate for this but I don't know for sure.

Cheers for the info
Good thing is I need custom made exhaust from turbo back so this will sorted bud I don't have idea where to have it done?
There is a Powerflow company in Basingstoke,anybody have any opinions about them?