You can change the style the forum displays by selecting your preferred style at the bottom left of the site.
We have made an enhancement so that old threads should now link from search results to the correct thread. This is not yet in place for single post links
OK - I'm familiar with K-Typ. No problems - I just haven't seen an elegant way to install it in the hoses. I was thinking of some small metal pipe carrying the sensor - fitted in between two silicon hoses.
Do you have a pic of the method used to fit the K-Typ into the hose ?
OK - I'm familiar with K-Typ. No problems - I just haven't seen an elegant way to install it in the hoses. I was thinking of some small metal pipe carrying the sensor - fitted in between two silicon hoses.
Do you have a pic of the method used to fit the K-Typ into the hose ?
Yes sure, its much better with full hard pipe work turbo to TB but no reason why it cant be done on a Standard set up.
I think fitting such bungs to the intercooler is good - then you can measure its efficiency nicely - but it would also be nice to have them in the hoses in/out of IC - so that improvements from S2 to RS2 (or bigger) IC can be effectively measured.
The efficiency of a LLk is computed as follows: Temp. Radiator entrance - temp cooler outlet/temp. Radiator entrance - external temp 130°C - 28°C/130°C - 10°C = 0,85 This value of 0,85 is very good! With the RS2 about so: 200°C - 58°C/200°C - 25°C = 0,81 In hold back-eat to his surface is also very good the small RS2 LLk with 0,81 In addition one must however still say that the RS2 LLk nearly whole in the wind lies, which large LLK to the half cover is there some more potential for possible new projects….
Funny, this exact setup i have on my car, works really great, but i thought it wasent so good tho.
Havent got any problems with intake temp so maybe it´s ok then
i must say that having those temps brought down are quite good,but it just goes to show of what a good quality intercooler can give with less dimentions.
mine is 500x300x65mm and on a 30C day gave me around 35C inlet temp on a 3d gear pull and 2bar overboost holding 1.5bar to the redline.So bigger is always better obviously,but good quality makes a difference! I bet that after the wagner inlet manifold thigns may get even better!
Hi,
please look at you the temperatures in the 6.Gear with 250km/h! That means full load at least for 30 seconds! In the 3rd course the full load is only 5 seconds or like that…. It lasts also its time to itself the intercooler warmed up….
It is better then RS2 Intercooler .....
I would see gladly times the temperatures of Wagner IC...
thomas, unless i come to germany i cannot do that test for you. But i will gladly do it next march(if my wife lets me to go that fast!! hehe) since i will travel through germany to go back to greece.I can then tell you the temps.
That size is fine. You shoulnt see any lag from using a bigger ic. It's only fractions of a second more to pressurerize a larger ic. I even had .1bar more top end after the install
We process personal data about users of our site, through the use of cookies and other technologies, to deliver our services, personalize advertising, and to analyze site activity. We may share certain information about our users with our advertising and analytics partners. For additional details, refer to our Privacy Policy.
By clicking "I AGREE" below, you agree to our Privacy Policy and our personal data processing and cookie practices as described therein. You also acknowledge that this forum may be hosted outside your country and you consent to the collection, storage, and processing of your data in the country where this forum is hosted.
Comment