Audi Coupe Quattro 2.3 20V - Czech Republic

[diogocartier]

Nice job!

[Tom_]

Thanks

Today a clean a outer CV joints on drive shafts...

after cleaning,but before grinding


u can see some rusty nasty surface


cleaned and grinded


from other sides

[Tom_]

Finally i get ABS sensors out,so tomorrow i get parts to sandblasting...Today a little bit clean and grind sleeves and using rust removal,and some money saved on important parts...

[Tom_]

Bye, Bye, rusty parts. I hope,that when u come to see me again,u will look good enough to get worked again Now its time to paint the exhaust and other parts and than worked on the bottom under the car.

[irishs2]

Wow, didnt expect to see a split open subframe
Its great to see the attention to detail you are give it, and its interesting to follow it.

[Tom_]

irishs2: Thank you mate. I try to give best care what i can...I think that its the best resolution to cut out subframe,because of good sanding inside and protect from rust..

[Tom_]

I ve got a mistake, there should be 5 000 zl, not 3 000zl .

Today a paint ss exhaust to black.When the exhaust was new,he was shiny,but after years, he get some dirt and loose his shine.And painted cv joint metal..
after paint


before paint

painted cv joint metals

[Tom_]

diff mount before painting


exhaus before paint



diff mount after painting (shining so much,that camera cant take that )





and with new diff bushing (thanks Des) Looks very strong


and exhaust after paint



and at the end of the day, brake and fuel lines were remove from the car

[rs200]

perfect job you done.. just keep going on

[Tom_]

Thank you

Yesterday i stripped a brake and fuel lines.Brake lines looked very rusty,and it was a time bomb,when they get broke.Fuel lines looked little bit better,but i decided to keep them out too.

diff lock housing before grinding





after grinding (looks better,but not perfect)



after using a rust removal






And brake T piece,after grinding and painting

[Tom_]

painted


before cleaning


after



looks better

[Tom_]

parts blasted (looking perfect,when u compare before and after)


































painted with special primer






control arms welded and stiffed

[Val]

wow, great progress.
In Latvia you are not allowed to weld subframe, so it would be MOT fail.

http://en.wikipedia.org/wiki/MOT_test

[Tom_]

MOT fail?What is that? I know what is fail but not MOT

[Tom_]

Almost all parts painted with primer,except springs and subframe


Subframe after welding,before painting