3b s2 coupe resurrection

[8690q]

Getting somewhere now, top stuff !
I might be tempted by a wee burl one night if you're up for it. I Think David might need a wee run too as he loved the purr as it started up and drove off the other night.

[andy10v]

Yeah, no problem at all. I will give you a shout once the proper injectors are in.

Good stuff, get him addicted at an early age

[andy10v]

M18-1/2 adapters arrived, but they have a taper on the m18 side that goes into the block, and a flat face on the 1/2 side that is supposed to connect to the oil line

Correct adapters now ordered.

After a cold start AFR is in the 10s at idle.

[Error404]

PITA! Where did you get the cooler kit from mate?

[andy10v]

http://www.ebay.co.uk/itm/BEK147S-MG...E:L:OU:GB:1120

Based on this thread

http://www.s2forum.com/forum/showthread.php?t=61411&highlight=oil+cooler

I got two long lines as somebody in that thread needed them, and gives me more flexibility, I think it would look tidier with the one long and one short as per the thread.

[Error404]

Cool, looks good mate. I will need to sort something out at some point

[andy10v]

Kinda hard to beat for the money, and suits me as functional.

Loyd's and twenty valve's were a bit more oem plus (I wanted mine up higher though, too vulnerable for my liking)

http://www.s2forum.com/forum/showthread.php?t=54762&highlight=oil+cooler

I was messing about with it and you could also fit it where the towing eye is, but that seems a bit optimistic

[newsh]

Me too, although I did buy a new core for the 3B setup, haven't fitted it yet

[andy10v]

Me too, although I did buy a new core for the 3B setup, haven't fitted it yet

Did you get the bigger one from some VW?

[Error404]

the larger 3B unit is from a T3 van IIRC.

I might get one of those you linked to Andy for my next project - diff oil cooler for the rear Torsen

[andy10v]

the larger 3B unit is from a T3 van IIRC.

I might get one of those you linked to Andy for my next project - diff oil cooler for the rear Torsen

Cheap enough to mess about with. Do you know the torsen is getting too hot, or just suspect it?

Still looking at stealing a JDM pump?

[Error404]

The theft has already taken place, I have a pump off my brother's old S14.
He left it here for me to do the wheel bearing so I took payment in the form of parts off his car. He sold it now, and never found out

Yeah I think the oil gets pretty toasty on track, have a feel of the casing after you've done a few hot laps.

[newsh]

Yeah I got a VW one off eBay.

[andy10v]

RS2 injectors arrived today from sailaz



440s out, swapped the 7A fpr back in.





Now fires up on the key, idles about 14.5-15.5, cruises similiar, enriches as under load, 10.X when WOT

Now drives beautifully, silky smooth, progressive and quite insanely fast

[stocious]

Glad you got it sorted