UrS4 2.2T Avant project

[Thuppu]

Good point

[Thuppu]

Oilpans finished. Had little trouble to fit them on my milling machine so had to make a jig so I could machine the face flat.

[Greg_S]

Lovely engineering as always

[Thuppu]

Dry sump kits ready for install...

[amarider]

Thuppu, I have some trigger-issues with MaxxECU with stock Audi-sensors.

What "trigger arm voltage" & "home arm voltage" and other settings are u using ?
Have u changed some of the values ??

Sorry for hijacking your project-thread.

Very nice project


/M

what ever happened here? We are struggling to get cam position sensor to read on Maxxecu. The flywheel sensors look fine. Someone saying we should try 12v(input) hall sensor?

[Prosac]

Hi Thuppu, have you balanced your 2.5Tdi crankshaft? Should you balance them IMPERATIVE? I have already heard that there are various 2.5L with AEL block and 95.5 crankshaft where nothing was balanced.

[Thuppu]

Hello! No, I have not balanced it, but of course it would be a good thing to do.

[Kiku]

What dry sump pump will you be using? If you have thought about that?

[PRY4SNO]

Hi Thuppu, have you balanced your 2.5Tdi crankshaft? Should you balance them IMPERATIVE? I have already heard that there are various 2.5L with AEL block and 95.5 crankshaft where nothing was balanced.

It'll run, but you'll be surprised how much work it takes to zero balance your diesel crank when you get around to it. If you can't zero balance everything at once, wait until you can. And proceed with a measure of caution.

Just my 2 cents.

[Tom_]

Any updates Thomas? Seems to quite a while

[Thuppu]

Pending time and motivation

[PRY4SNO]

Pending time and motivation

Godspeed, friend.

Time, will, and pockets able; which don't often reside in time together.

[Acki]

Somewhere I found the information about the external imbalance of the stock flywheel. May this cause some issue with balancing everything to zero.

[rxl]

stock flywheel the single mass one has a disbalance of 27g.

[Spyform]

Whats up?