Terrybullwon's Racing S2 coupe

[terrybullwon]

Few pages back David



Welded in at the lowest point, this will take the wagner intercooler and flat floor.

[terrybullwon]

Jay at DMD will sell you a set

[terrybullwon]

I take it this is all ali tubing? Let have a look at your welds?!

Here you go Andy









All free hand and most of it done in place with the frame in.

I treated my self to this

[terrybullwon]

******Note*****

That gas lense is not for AC work!

[AndyP]

Nice work, I'm getting pretty good at straight line stuff in ali, but I must admit I need more practice on circular stuff.

Where did you get the big lens from? I've just ordered something similar from here

https://www.arc-zone.com/

Prices are pretty good but postage is expensive so I waited and ordered a few things.

[AndyP]

you should try one of these too:-

http://www.rapidwelding.com/dynamic/...2112HSFFX&zl=4

The CK superflex cable is so light and flexible you almost don't know it's there, so much better than the std RTech cable

[terrybullwon]

Nice work, I'm getting pretty good at straight line stuff in ali, but I must admit I need more practice on circular stuff.

Where did you get the big lens from? I've just ordered something similar from here

https://www.arc-zone.com/

Prices are pretty good but postage is expensive so I waited and ordered a few things.

Thanks Andy, i must admit my work where i can sit and use the work bench is much better. I am now proficient in upside down back to front and left handed welding. Chassis fabrication is at every angle!

I've mentally just spent £200

This is the cups i brought

http://www.dogfab.com/FURICK_CUPS.php

you should try one of these too:-

http://www.rapidwelding.com/dynamic/...2112HSFFX&zl=4

The CK superflex cable is so light and flexible you almost don't know it's there, so much better than the std RTech cable

I've been putting off getting a CK torch i brought a speedglas instead. I must say its made a massive difference i would highly recommend one. Rapid weld deliver to my friend i get my gas from maybe i will stick one on order. Is that the one you have?

[AndyP]

I havn't got that one yet, they do a 150amp version, which for some reason is only about £60. I bought that one just to see if it was any good, now I know how good they are I'll get the full 200amp one

[terrybullwon]

I've ordered one. Lets see how i get on with that. Really need a water cooler as well, But i dont do enough AC work to really warrant it.

[terrybullwon]

So dampers were sorted on the front and rear again.

Had to remove the dead stroke and machine my own cylinder tops with a O ring to get them to work with the new lower COG of the front

They are now rocking Ohlins internals.

Springs have been changed i have gone up front and rear.











Note. Eibach springs



For Andy

[AndyP]

Have you tried it yet?

[terrybullwon]

Yep.... It's amazing.

[AndyP]

Told you

[Mcstiff]

Seriously envious of the struts! Exactly what I need on my 90.

[terrybullwon]

Seriously envious of the struts! Exactly what I need on my 90.

Don't buy Ast!

Your have to sort them and Dyno them your self. Buy Ohlins.

A shameless plug for Jay @DMD had to drop this out with the dampers. 6 bolts and its straight to the floor. Off to be powder coated white and the diff pre load re shimmed as its worked its way loose.