The plate sits on top of the coils without spacers so not ideal but maybe yours will be OK
Announcement
Collapse
No announcement yet.
New S2 Avant Nothelle N300 owner
Collapse
X
-
Originally posted by Rikki Kitto View PostThe plate sits on top of the coils without spacers so not ideal but maybe yours will be OKNothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
Comment
-
One of the RS2 door cards was damaged in the “little” accident Cardcrash had.
So I swapped the leather look fabric over. First glued some new foam backing.
Cleaned all the old adhesive off the door.
Then glued it back on.
Two down, two to go.
Sent from my iPhone using TapatalkNothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
Comment
-
All done
The aluminium clips worked. Hope they hold. I did try to re glue a plastic one but it snapped off while I was re fitting the card.
I was just thinking about radios then noticed my Ariel wire is missing!
It must be lost in the spaghetti behind the dash.
What route does it take from the bee sting?
Sent from my iPhone using TapatalkNothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
Comment
-
Remember this plug?
I found out where it should be.
It’s the rear speaker connector and should be up where the stereo is.
Don’t know how it got where it is or how I’m going to pull it back.
it connects to the smaller black plug you can see in the pic showing the stereo hole.
Sent from my iPhone using TapatalkLast edited by Tractor Dave; 13 January 2019, 12:47.Nothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
Comment
-
Originally posted by Rikki KittoMight be easier to chop and lengthen it bud
Sent from my iPhone using TapatalkLast edited by Tractor Dave; 13 January 2019, 19:11.Nothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
- 1 like
Comment
-
I got some new pedal rubbers. The old ones were very worn.
They are not easy to get on. Very tight. I found the best way is to warm them up a bit in some hot water.
All done
Sent from my iPhone using TapatalkNothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
- 1 like
Comment
-
I’ve been crawling around in the footwell again. Had to take all the lower trim and vents out to release the speaker wire. Still looking for the Ariel wire!
Sent from my iPhone using TapatalkNothelle S2 Avant
Black Ur project
Ocianic Ur project gone
S2 Coupe project gone
Urs6 plus project gone
Comment
Comment