Terrybullwon's Racing S2 coupe

[DNA-S2]

Looks fantastic mate!
Can't wait to see it in flesh
[emoji102][emoji106]

[G60Rallye]

Thats a huge saving, I didn't expect that much! I was thinking today does this rule you out of time attack now as its a spaceframed front end?

[terrybullwon]

Looks fantastic mate!
Can't wait to see it in flesh
[emoji102][emoji106]

Thanks Danny

Thats a huge saving, I didn't expect that much! I was thinking today does this rule you out of time attack now as its a spaceframed front end?

All the steel that came out weighed in at 48kg

My old flat floor , splitter and bumper weighed 23kg

Old Engine harness including 034 coils 3kg

Brakes i have saved 3.5kg a corner

Wishbones 1.5kg a corner

so rough total of 83kg ish...

New frame so far has used 2 lengths of 4130 at 3.5kg and 2 smaller wall at 3kg so by the time i have started on the Ali frame i should be well under....

New Flat floor is Honey comb and carbon. I have not decided yet if i will wet lay up some wheel arch liners. My corner weights are going to be amazing this time around!

It means it goes into pro extreme. I paid my £50 drivers registration fee so i might make a few rounds next year

[terrybullwon]

Welded top mounts, not to bad considering i was at the christmas staff party the night before

[my2000apb]

Sweeeeet!!!!!

[piotr]

Wow,Fantastic job

[A1QSHIP]

Thanks Danny



All the steel that came out weighed in at 48kg

My old flat floor , splitter and bumper weighed 23kg

Old Engine harness including 034 coils 3kg

Brakes i have saved 3.5kg a corner

Wishbones 1.5kg a corner

so rough total of 83kg ish...

New frame so far has used 2 lengths of 4130 at 3.5kg and 2 smaller wall at 3kg so by the time i have started on the Ali frame i should be well under....

New Flat floor is Honey comb and carbon. I have not decided yet if i will wet lay up some wheel arch liners. My corner weights are going to be amazing this time around!

It means it goes into pro extreme. I paid my £50 drivers registration fee so i might make a few rounds next year

What does that work out to cost per kilogram?

[terrybullwon]

What does that work out to cost per kilogram?

I stopped adding up what I spend on it along time ago..

[Wizard-of-OD]

Money shot......

James what ratio are you turning that pump?
3:1?

[terrybullwon]

Dude are you advertising in my project thread???

This stuff is all home made.

[GazzaG60]

wow your engine holder looks like mine except mines steel and made by rover

lol for the chancer with the advert

[Jamo]

What advert?

[A1QSHIP]

What advert?

[terrybullwon]

James what ratio are you turning that pump?
3:1?

Its 57% of engine speed i'll have a count up if i remember

What advert?

Cheers buddy


Thanks to Jay @ DM Developments for the conical weld in mounts for my aluminium front frame they are 870 grms for all 4. So hardly pushing the boat out. Also knocked me out some wishbone brackets so i could finish the front end and fully weld up.



Welded in at the lowest point, this will take the wagner intercooler and flat floor.



As you can see the frame is pretty much done now and will be ready for set up and paint in Jan. Top mount angle perpendicular to strut is extreme as it looks in the photo

[AndyP]

Welded top mounts, not to bad considering i was at the christmas staff party the night before

Nice work