UrS4 2.2T Avant project

**V6quattro** · 11 April 2012, 17:57

Nice bends. Its really important to cut straight for the TIG welds i think. When do you start on the exhaurst? Looking forward to see your work.

**Thuppu** · 11 April 2012, 18:02

Yes, you'r right, it is inportant. Or lets say, it's more simpple to weld. I'll start on it when I get the engine in place, hopefully next week.

**fish** · 11 April 2012, 19:25

The flex is actually a copper pipe with rubber coating., and a flex torch is alot nicer to work with!

**J_ones** · 11 April 2012, 20:35

Nice to see some good progressing! Unlike my project...

**Thuppu** · 13 April 2012, 14:15

Got the oil return line...

**Prosac** · 14 April 2012, 16:18

Is this an Twinscroll- Housing? The manifold too?

**Thuppu** · 14 April 2012, 19:49

Yes, a T3 twinscroll housing, but not a twinscroll manifold because there is 5 runners.

**Nuno Cristiano** · 14 April 2012, 20:15

Nice project

I´m waiting by results

**Prosac** · 17 April 2012, 23:41

Hello
can you tell me what was the reason for the rods bearing damage?
Oilpump?

**Thuppu** · 18 April 2012, 12:45

Can't say for sure. Oil pump is one possibility.

**Jim_Coupe** · 18 April 2012, 12:51

Really nice project

**Prosac** · 19 April 2012, 00:33

Ok. Was the oilpump a new one OEM from VAG?

**Thuppu** · 19 April 2012, 02:14

Now I have a new OEM one. It will be interesting to see how different the pressure will be compared to the old setup.

**Melber** · 19 April 2012, 08:37

You would like to put custom pump gear, or decided not?

**Thuppu** · 19 April 2012, 09:50

Yes, I will use the custom Cr-mo gear.

Comment